Installation Instructions

COUNTERTOP
Made in Italy
TG0817
Made in Italy
TG0818
Model ISD 1
REQUIRED TOOLS:
Pull and remove dispenser
sleeve (A) from threaded body
(B). Slide base ring (C) over
threaded body. The base ring
sits on top of the counter.
Fit threaded body (B) through install hole. (No
plumbers putty is required. 0-ring seals the base).
Slide rubber gasket (D), mounting washer (E)
and thread mounting nut (F) over threaded body
in that order.
Tighten mounting nut (F) snuggly to
underside of counter and securely
tighten mounting nut screws.
#2 Phillips Screwdriver
1 MIN TO 1 3/8 MAX
INSTALL DIAMETER
HOLE
H
Slide tubing (H) into tube
fitting inside of dispenser
sleeve (A).
Place dispenser sleeve (A)
with tubing (H) on the
threaded body.
Pump knob as many times as
necessary to get soap or lotion
flowing. Immediately remove
any soap or lotion spilled on
the product.
A. Dispenser sleeve
B. Threaded body
C. Base ring
D. Rubber gasket
A
B
C
D
G
E
PARTS INCLUDED:
E. Mounting washer
F. Mounting nut
G. Soap bottle
H. Tubing
F
Ensure Galley logo on base
ring is facing forward before
tightening.
NOTE:
To refill soap dispenser,
simply lift dispenser sleeve
off of the threaded body
and pour soap into threaded
body until full (Max of 12 oz.).
Replace dispenser sleeve.
NOTE:
1
2
3
4
5
6
7
8
1 9/16 MAX
COUNTERTOP
THICKNESS
Pour 12 oz. of soap into soap bottle (G) (Avoid
using thick soap). Thread soap bottle into bottom
of threaded body until secure.