Installation Instructions

3. INSTALL THE WORKSTATION BASIN

a) A support frame (cleat system) will need to be built

and installed into the cabinet(s). This frame will support

the weight of the Workstation. Note: Clips are NOT to

be used.

b) Construct the support frame so that the inside

dimensions are 1/2" larger than the basin’s inside

dimensions. Please refer to pages 1-3 for your

Workstation dimensions.

NOTE: For a Workstation + DryDock™, the support

frame must be built with 1” x 2” boards.

a) Carefully place the Workstation into the cabinet

by resting the flanges on the support frame. All four

flanges should rest upon the support frame.

b) Use a level to ensure that the flanges are level.

c) The top of the flanges should be flush with the top

of the cabinet.

1. CONSTRUCT SUPPORT STRUCTURE

**IMPORTANT**

Support frame must be installed 1/16" lower than the

top of the cabinet. Once installed, the top of the

Workstation Flanges will be flush with the top of the

cabinet.

Use a level to ensure that the support frame is

installed level in the cabinet.

2. ATTACH THE SUPPORT FRAME TO THE

INTERIOR WALLS OF THE CABINET

1” x 6” HARDWOOD BOARDS ARE RECOMMENDED

EXCEPT FOR WORKSTATION + DRYDOCK, FOR

WHICH 1” X 2” ARE RECOMMENDED.

OVERHEAD VIEW