Specification Sheet

Countertop Cutout Plan
Tap Hole Specifications
IWS 4S + DryDock
™
12 in stock
FRONT AND BACK
1/2" (13 mm) REVEAL
C.O.
18"
(457 mm)
16"
(406 mm)I.D.
10"
(254 mm)
C.O.
(1435 mm)
56 1/2"
LEFT AND RIGHT
1/4" (6 mm) REVEAL
CABINETS ARE
TYPICALLY CUSTOM
MADE FOR GALLEY
DIMENSIONS. FOR
EXISTING CABINETS,
TRIM INTERIOR
BULKHEADS APPROX.
11
" (280 mm) TO CLEAR
SINK DEPTH.
(41 mm)
1 5/8"
44"
(1118 mm)I.D.
INSTALL SUPPORT CLEAT
1/16
" (2 mm)
TOP OF CABINET.
NOTE: PLEASE ALLOW A MINIMUM
BELOW THE COUNTER TOP.
10"
(254 mm)
48"
(1219 mm)
(CABINET LENGTH
)
24"
(610 mm)
(OPEN SPACE LENGTH)
72"
(1829 mm)
(OVERALL LENGTH
)
12"
(305 mm)I.D.
SPECIFICATIONS | Left Hand Drain Orientation
STAINLESS STEEL COMPLIANCE ASME A112. 19.3-2008/CSA B45.4-08
WE RESERVE THE RIGHT TO MAKE REVISIONS WITHOUT NOTICE IN THE DESIGN OF PRODUCTS OR IN
PACKAGING UNLESS THIS RIGHT HAS SPECIFICALLY BEEN WAIVED AT THE TIME THE ORDER IS ACCEPTED.
DWG and DXF templates available on our website:
TheGalley.com/specification-library
Questions? For additional assistance, please contact
The Galley's Customer Service Department at 800.375.4255
SUGGESTED GALLEY TAP PLACEMENT GUIDE
Suggested maximum inside corner radius of countertop cutout 3/8”
Galley Tap 1 3/8” min to 1 1/2" max hole diameter
Center Tap hole diameters 2” behind cutout
Note: Galley Hot & Cold Tap requires a minimum 8" clearance to center if installed to the right of the Galley Tap
Note: Tap Placements are for right hand or left hand drain orientation
T
Call 800.375.4255 or email [e-mail]
for additional guidance on Tap and Tap Accessory placements
3/4"
(19 mm)
(32 mm)
1 1/4"
(32 mm)
1 1/4"
(19 mm)
3/4"
THE GALLEY TAP
FAUCET
(38 mm)
1 1/2"
(114 mm)
4 1/2"
C.O.
18"
(457 mm)
(51 mm)
2"
16"
(406 mm)I.D.
11"
(279 mm)
34 1/2"
(876 mm)
24"
(610 mm)
(CABINET DEPTH)
Important Installation Note: DryDock requires 2" minimum clearance below countertop
Inside Dimension 17”
Inside Dimension 44”Inside Dim. 12”
Cutout Dimension 18”
Outside Dimension 19 1/2”
22 1/4”34 1/4”
8”
8”
Outside Dimension 57 1/2”
Cutout Dimension 56 1/2”
2 1/8" (54 mm) O.D.
OF 2 1/8" (54 mm) HEIGHT CLEARANCE
LOWER THAN