Use and Care Manual

Be certain to slide the H.D. Rolling Door Lock main body as far to the left as you can
enclosing the rolling door handle latch hook within the forks of the H.D. Rolling Door Lock.
Align the “U” shaped body so it will slide over the door’s locking lever while being
received in the main body.
Once properly fitted, be sure to slide the “U” shaped body as far right as possible to
secure the rolling door handle and depress the locking button. Or with the changeable
combination lock, scramble the numbers and depress; therefore securing the lock in place.
Congratulations! Your Rolling Door Lock is installed. Secure the keys in a safe place.
However, if the “U” shaped body is too far to the left, it is NOT correctly installed as it
leaves the handle susceptible to exterior tampering.
INSTALLATION INSTRUCTIONS:
HEAVY DUTY ROLLING DOOR LOCK
WWW.EQUIPMENTLOCK.COM TOLL FREE: 1-866-565-4887 [e-mail]
INSTALLING THE H.D. ROLLING DOOR LOCK
1.
2.
3.
4.
Slight adjustment may be needed to remove pressure from the pin.
Available in both Keyed and Combo Locks
Combination Code Reset Directions Included (Separate Sheet)
Insert key and turn one quarter turn clockwise or turn dials so lock mechanism “pops out”.
Carefully lift the “U” shape off of the main body and locking lever.
Slide the main body to the right and remove from behind the door’s locking lever.
Assemble the two parts together and store it in a safe place until you use it again.
REMOVING THE H.D. ROLLING DOOR LOCK
1.
2.
3.
4.
NOTE:
FIGURE 1 FIGURE 2
HEAVY DUTY ROLLING DOOR LOCK COMBO HEAVY DUTY ROLLING DOOR LOCK KEYED