User Manual

User documentation The Confetti Maker FX Ⓡ
Preparation
Unpack the E-Shot and make sure the device is undamaged. If the device is damaged
Please contact your supplier as soon as possible.
Use of the E-Shot
1. Place the confetti tube into the holder.
2. Tighten the confetti tube with the rotary knob.
3. Connect the female connector to the from the confetti tube to the male connector
in the E-Shot.
4. Connect a Powercon cable to the E-Shot.
5. Power the E-shot to activate the confetti tube.
Maintenance
To ensure the proper functioning of the E-Shot, the E-shot must be regularly cleaned
and tested.
To test the functioning of the E-shot, power the E-shot with a Powercon without a
confetti tube connected. Please contact your supplier if the LED does not light up.
Using the E-Shot
The E-Shot in combination with a switchpack can be controlled with a control panel.
When the E-shot is powered with 230V, the output connector will supply a current
through the confetti tube that will fire the confetti between 8 and 12 meters.
Warning!
Do not Aim the Confetti tubes in the E-shot at people or animals.
The distance between the crowd and the E-shot should be at least 3
meters.
Malfunctions and Repairs
The Confetti tube did not fire?
- Remove the confetti tube
- Make sure the E-Shot is connected to 230V
- The LED on the E-Shot serves as a functionality check.
The LED lights up but doesn’t fire confetti tubes.
- Make sure the E-Shot is connected to 230v.
- Make sure the Powercon cable is undamaged.