Installation Manual

Customer support is available Monday through Friday 9:00am to 5:00pm PST
at 866-409-9634
JSB Enterprises
Temecula, CA 92590
www.thecanconverter.com
(Turn the power back on at the breaker
box. Your installation is now complete)
Raise the fan canopy to the fan hanger bracket
Secure the canopy in place by using the two
canopy's attachment screws.
18.
CEILING FAN
18.
17.
Using wire nuts, pair together the fixture's hot
wire, to the power-outlet-adapter's hot wire,
the fixture's neutral wire to the power-outlet-
adapter's neutral wire and the fixture's
ground wire to the power-outlet-adapter's
neutral wire. Capture the wiring inside the fan
canopy
CEILING FAN
17.
16.
Lift the fan and capture its ball joint in the fan
hanger bracket. Cut off any excess wiring.
CEILING FAN
16.
15.
Raise the medallion up to the ceiling, followed
by the fan hanger bracket. Run the power-out-
let-adapter wires and ground wire through the
side of the fan hanger bracket. Using the long
screws supplied with your fan, screw the fan
hanger bracket to the appropriate holes in the
mounting plate.
CEILING FAN
15.
Brass Nut
14.
Screw the mounting plate onto the threaded
pipe so that the plate rests against the heads
of the screws on the mounting bracket. Thread
the second nut through the wires. Screw the
brass nut up the threaded pipe all the way to
the mounting plate. Tighten the brass nut to
secure the mounting plate to the threaded
secure the mounting plate to the threaded
pipe.
CEILING FAN
14.
Brass Nut
13.
Remove the medallion. Screw the brass nut
onto the threaded pipe all the way up to the
mounting bracket and tighten the brass nut.
CEILING FAN
13.
1/4 INCH
12.
Place your medallion at the can light opening
against the threaded pipe. Screw the pipe
upward so that it extends beyond the medallion
by 1/4 inch.
CEILING FAN
12.