Installation Manual

(Turn the power back on at the breaker
box. Your installation is now complete)
19.
Raise the medallion, the light canopy and
fixture to the ceiling. Secure the canopy by
attaching the fixture's decorative nuts to the
extending screws. Alternately drive the nuts to
the fully tightened position. The screws will
back drive then stop when they are tightly in
place.
PENDANT
19.
18.
Using wire nuts, pair together the fixture's hot
wire, to the power-outlet-adapter's hot wire, the
fixture's neutral wire to the power-outlet-adapt-
er's neutral wire and the fixture's ground wire to
the power-outlet-adapter's neutral wire. Tuck all
of the wiring into the
fixture's canopy.
PENDANT
18.
17.
Bring your fixture and medallion to the can light.
Cut off any excess wiring.
PENDANT
17.
Brass Nut
16.
Thread the second nut through the wires. Screw
the brass nut up the threaded pipe all the way to
the mounting plate. Tighten the brass nut to
secure the mounting plate to the threaded pipe.
PENDANT
16.
Screw the mounting plate onto the threaded pipe
so that the plate rests against the heads of the
screws on the mounting bracket.
15.
PENDANT
15.
Run the wires from the power-outlet-adapter
and ground wire down through the hole in the
mounting bracket. Run the wires through the
threaded pipe then screw the pipe into the
mounting bracket.
11.
CEILING FAN
11.
10.
Loosen the wing nuts on the flat head screws.
Place the medallion you will be using against
the ceiling and adjust the length of the screws
so that the heads rest about 1/16th inch inside
the back of the medallion. Then tighten the
wing nuts.
CEILING FAN
10.
If you are using the flat medallion, adjust
the screws so that the heads are inside
the can. Then tighten the wing nuts.
CEILING FAN INSTALLATION