Installation Manual

Pre-assemble your new light fixture following the manufactures instructions. For chandelier installation continue to
STEP 10 CHANDELIER. If you are installing a pendant, track lighting or other fixture that will be secured to a
mounting plate, continue to STEP 10 PENDANT. If you are installing a ceiling fan, continue to STEP 10 CEILING FAN.
ALTERNATE INSTRUCTION PATH
9.
Loosen the wing nuts on the flat-head screws and adjust them
so that the heads are level with the baseof the can. Tighten the
wing nuts to lock the screws in position.
Can Interior Cross Section-Cut Away View
9.
If the screws in your existing can ARE in a triangular
configuration, remove them and replace them with
the CAN CONVERTER self-tapping screws. Half the
length of the screws should remain exposed.
fig. B
Use the existing holes to mount the offset-bracket
assembly. Set the off-set sliders onto the three
self-tapping screws and lower the sliders onto the
lock position.
Figure A
Figure B
8. fig. A
8.
7.
fig. A
Re-insert the mounting bracket assembly and position
the offset sliders onto the three self-tapping screws
and lower the sliders onto the lock position.
fig. B
Tighten the screws securely into the can housing.
Figure A
Figure B x3
7.
Using a power drill, screw the self-tapping screws into
the marks you made. Half the length of the screw should
remain exposed.
6.
Loosen the self-tapping screw and remove the mounting
bracket.
fig. A
fig. B
Figure A Figure B x3
6.
Loosen the wing nuts and slide the two unattached
offset-sliding-brackets so they make contact with the
inside wall of the can housing.
fig. B Mark the positions of the two empty offset-bracket holes
on the can housing.
5.
fig. A
Figure A
5.
Figure B