Installation Manual

IMPORTANT: Verify proper can installation, bar hangers must be resting on ceiling
Use eye protection when working
over your head
Turn off power at the breaker box
Set the assembled mounting bracket in position to use the
empty screw hole. Using a CAN CONVERTER self-tapping
screw, attach one of the offset-sliding-brackets to the can
housing.
Figure A
fig. A4.
If the screws that attach the metal can to the wall are not in a
triangular configuration, remove one of the screws.
fig. B
Figure B
4.
Figure B
If the socket is NOT adjustable, remove the socket from the
trim and screw the CAN CONVERTER power-outlet-adapter
into the socket.
fig. B
Figure A
fig. A
Within the can housing, there is a metal bracket that holds
the light socket. If it is adjustable, loosen the wing nut and
slide the bracket to the top of the can housing. Tighten the
wing nut andscrew in the CAN CONVERTER power outlet
adapter.
3.
Can Interior Over-head View
3.
Put the mounting bracket assembly together using
the three offset-sliding-brackets and the three
flat-head screws and wing nuts.
If your can light housing is too narrow, use the three #10 nuts
in place of the wing nuts.
fig. C
fig. A and B
2.
Figure C
Figure A
Figure B
Remove the light bulb and can trim from the can light you will be
replacing.
1.
1.