User manual

8 [115V/60Hz — 230V/50Hz]
Selector switch for the power supply. Make sure that, before activating the device, the switch position is set to the
local supply voltage.
9 [LINE/MIC]
Button to select the input sensitivity of the speaker (line or microphone level). Push the push-button with a suitable
sharp tool, e.g. a ballpen.
10 LED [LINE]
The LED lights in operation when the input sensitivity is set to LINE.
11 LED [MIC]
The LED lights in operation when the input sensitivity is set to MIC.
12 [120Hz]
Low cut switch to lower frequencies below 120Hz. This function reduces impact noise and maximize the lifetime of
the woofer.
13 [CLIP]
Indicates overload. If the LED flickers or is lit, the input signal level is too high.
Connections and operating elements
active 2-way-full-range-speaker
20