User manual

Each device of a Pronet network must have a unique identier or ID. By default, the USB2CAND
converter has the ID 0. Any other device can only have an ID equal or higher than 1. There
must be no devices with the same ID on the network. The ID is assigned automatically when a
device connected to the network is turned on for the rst time.
Proceed as follows to assign a unique ID to all devices in the Pronet network:
1. Turn o all devices.
2. Connect them with the RJ-45 network cables in the desired order.
3. Press the [TERMINATE] button on the rear panel of the last unit.
4. Turn on the rst device while holding down its [PRESET] button on the rear panel.
5. Leave the rst device turned on and repeat step 4 for all other devices until the last
device is turned on.
When a new device is to be added, only step 4 must be repeated. Each device keeps its ID,
even if it is turned o, as it is stored in the internal memory of the device. The ID is only deleted
or reassigned by explicit allocation as described above. Find more detailed information and
instructions in the User Manual supplied with the Pronet software.
ID assignment
Networking and remote control
A 8 LA
31