User manual

This LED lights up when the user setting is loaded. This setting corresponds to the user preset no. 1 of the
DSP. In delivered condition, the user setting is identical to the setting [STANDARD]. If you want to change it,
you must connect the device to a notebook/PC using the CanBus converter, edit the parameters using the
Pronet software, and save the setting to user memory preset no. 1.
8 LED [SIGN/LIMIT]
This LED lights green when an input signal is present.
This LED lights red when the internal output signal is limited (due to excessive input signal level!).
9 LED [ON]
This LED lights green when the unit is turned on and the power supply voltage is present.
10 [MAINS IN]
Blue lockable input socket (Power Twist). To turn the unit on, plug the power cord or the connector cable from
another device into this socket and turn the plug clockwise to the position [ON]. To turn the unit o, pull the locking
lever on the plug backwards and turn the plug counter-clockwise to the position [PUSH OFF].
11 [POWER OUT]
Gray lockable output socket (Power Twist). This output is looped through from the blue input socket [MAINS IN]. You
can use it to feed the power supply to the input socket [MAINS IN] of further elements. A maximum of four line array
elements can be connected.
Connections and controls
A 8 LA
27