User manual

1 [INPUT]
Audio signal input with lockable XLR chassis socket. The socket is electronically perfectly symmetrical wired to ach‐
ieve an optimal signal-to-noise ratio and a sucient power reserve, including A / D conversion.
2 [GND LIFT] pushbutton
If hum is caused by a ground loop, you can use this switch to disconnect the connection between the earth pin of the
device and the signal ground of the device. Switching only has an eect when using balanced connection cables.
3 [LINK]
Audio signal output with XLR chassis plug to connect other line array elements or speakers to which the input signal
is passed.
4 [TERMINATE] pushbutton
If the devices of a line arrays are networked together, the last unit must be terminated with the built-in load resist‐
ance. Press the pushbutton [TERMINATE]. The LED above it lights up.
5, 6 [NETWORK IN/OUT]
RJ45 connectors (EtherCon) for establishing a connection to network, the Pronet software and the line array elements
Connections and controls
A 8 LA
25