User manual

This LED lights up when the user setting is loaded. This setting corresponds to the user preset no. 1 of the
DSP. In delivered condition, the user setting is identical to the setting [STANDARD]. If you want to change it,
you must connect the device to a notebook/PC using the CanBus converter, edit the parameters using the
Pronet software, and save the setting to user memory preset no. 1.
8 LED [SIGN/LIMIT]
This LED lights green when an input signal is present.
This LED lights red when the internal output signal is limited (due to excessive input signal level!).
9 LED [PROT]
This LED lights red when the protection circuit of the amplier module responds due to an internal error and the
amplier is therefore muted.
This LED lights red when the internal output signal is limited (due to excessive input signal level!).
10 LED [ON]
This LED lights green when the unit is turned on and the power supply voltage is present.
Connections and controls
A 10 LA
27