Instructions / Assembly

Threaded hole

Attach to wall

SEE OVER

Stand shelving unit upright and lean against unobstructed wall so that shelves are level.

3 SHELF UNIT WS1003

ASSEMBLY DIAGRAM

Delta Cycle Corporation

125 Washington Street

Foxborough, MA 02035 USA

IMPORTANT: READ ENTIRE INSTRUCTION BEFORE ASSEMBLY

Maximum load per shelf (spread evenly) 165lbs (75Kgs)

Failure to follow instructions can reduce the strength of this rack and the load capacity.

SAFTEY WARNING: Do not use as a step ladder. Never allow children to climb on rack.

In order to avoid accidental toppling of the rack, a wall stabilizing strap is supplied. This should be attached

to the rack at one end with the bolt provided. The other end of the strap should be secured to the wall using

a screw that is suitable for the type of wall construction. If in doubt, consult your hardware merchant for the

correct method of xing based on the wall construction.

PAGE 1
IMPORTANT: READ ENTIRE INSTRUCTION BEFORE ASSEMBLY Stand shelving unit upright and lean against unobstructed wall so that shelves are level. 5 In order to avoid accidental toppling of the rack, a wall stabilizing strap is supplied. This should be attached to the rack at one end with the bolt provided. The other end of the strap should be secured to the wall using a screw that is suitable for the type of wall construction.
PAGE 2
IMPORTANT: READ ENTIRE INSTRUCTION BEFORE ASSEMBLY PARTS LIST TOP TUBE with STRAP X 1 SHELF X 3 LEG TUBE with Foot X 2 ANCHOR KIT X 1 EXTENSION TUBE X 2 BOLT X 10 Insert extension tubes into top tubes, line up holes and screw in bolts. 1 Insert leg tubes (rubber feet on bottom) into frame as shown, line up holes and screw in bolts. 2 While frame assembly is face down on ground, determine shelf positions and attach shelves using bolts.