Instruction Book
AIR+WATER power | Contents Parts List ................................................................................................................................................ 1 Learning about Gears..................................................................................................................... 2-4 Learning about Sprockets ............................................................................................................... 5 Tips and Tricks for Building the Models .....
Parts List | AIR+WATER power No PARTS NAMES PCS No PARTS NAMES PCS No PARTS NAMES PCS 1 PRESSURIZED AIR+WATER TANK 1 14 LONG FRAME 5 27 LARGE PULLEY 2 2 WATER STORAGE TANK 1 15 LONG AXLE 2 28 SQUARE FRAME 1 3 WHEEL AND TIRE 2 16 EXTRA LONG AXLE 2 29 SMALL SPROCKET 2 4 SHORT FRAME 3 17 ONE-WAY SWITCH 1 30 SMALL GEAR 2 5 PUMP 1 18 CURVED ELBOW ROD 4 31 MEDIUM SPROCKET 2 6 AIR+WATER TURBINE 1 19 90 DEGREE CONVERTER - R 2 32 BASE PLATE 1 7 CAP FOR
Air+Water Turbine Models | AIR+WATER power 1 atmospheric pressure (atm) = 760 mmHg (torr) = 76 cmHg = 76 ยท 13.6 g/cm3 (density of mercury) = 1033.6 g/cm2 = 1.0336 kg/cm2 Therefore, 3.5 kg/cm2 of compressed air is equal to 3.4 atm. To grasp the potential energy of this pressure, you have to realize that mercury is 13 times denser than water. So, a pressure of 3.
AIR+WATER power | MODEL 1 Cutting Machine Parts Needed Cutting Machine x1 x4 x1 x1 x1 x2 x1 x1 x2 x2 x2 x1 x2 x 16 x1 x2 x1 x1 x1 x1 x1 x 36 x2 x1 x2 x3 Assembly Notes x1 x1 x4 1 2 1. The gears should mesh well with each other in order to operate smoothly. 2. Note that the sprockets must be aligned in order for the chain to operate smoothly. 3. Cut Tube A and Tube B to get tubes of the following lengths for this model. Tube A Tube B Tube A : 9.
MODEL 1 Cutting Machine | AIR+WATER power 12 13 14 16 17 15 20 21 18 19 22 23 24 25 27 28 26 29 30 31 32 Completed 13
