GPS Receiver User Guide

122 ProMark2 User’s Guide
Antenna Screen
The Antenna screen, Figure 4.15, lets you set the GPS antenna parameters of the point at which
data is being or will be collected. Table 4.12 describes the screen parameters.
d
Figure 4.15 Antenna Screen
Table 4.12 Antenna Screen Parameters
Parameter Description
Height Type Lets you select antenna height type: Slant or Vertical. Default is Slant
Antenna Height Lets you enter the antenna height in the units that are set in the Unit of Measure screen,
page 125. To change antenna height, the button sequence is as follows:
First, use the up/down arrows to highlight the Antenna Height data field. Then press
ENTER to go into edit mode. Now use the up/down arrows to move to a different digit.
After setting all digits, press ENTER, use the down arrow to highlight Save, and press
ENTER to save. Default is 0.000.
Save Saves settings.
Note: Parameters are saved after a power cycle.