GPS Receiver User Guide

Screen Descriptions 115
Screen Descriptions
Control Lets you set the point as a control point for future use as a known point initialization
point. Set to Yes and the point occupied becomes available as a known initialization
point and is included in the site id table. Set to No and the point is a standard point
occupation. The default setting is No.
Save Saves settings.
Note: After a power cycle, all parameters set will be saved with the exception of the Initialize setting (return to None)
and Control setting (return to No).
Note: Site description information is shared by the three different modes of operation. So site description entries
added, edited, or deleted in any of the survey modes of operation will reflect when in the other modes.
Note: Site ID information is shared by the stop-and-go and kinematic modes of operation. So site ID information
after a power cycle will reflect last site ID of stop-and-go or kinematic, whichever was last.
Table 4.5 Point Attribute - Stop-and-go Parameters (continued)
Parameter Description