Datasheet

34
detect the temperature probe and will display the
temperature probe data in channel 2.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. User shall remove all the batteries from the
Temperature Station and transmitters, and wait 60
seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first
transmitter, insert the batteries in the Temperature
Station. Once the batteries are in place, all
segments of the LCD will light up briefly. Following
the indoor temperature/humidity and the time as
0:00 will be displayed. If these information are not
displayed on the LCD after 60 seconds, remove the
batteries from both units and wait for at least 60
seconds before reinserting them.
4. The outdoor temperature data from the first
transmitter (channel 1 and 2) should then be
displayed on the Temperature Station. Also, the
signal reception icon will be displayed. If this does
not happen after 2 minutes, the batteries will need
to be removed from both units and reset from step
1.
5. If the temperature probe has been used, the
outdoor temperature from channel 2 will then be
displayed. Otherwise, the outdoor temperature will
display “---“.
Note:
The temperature probe from the first sensor
will always occupy “channel 2”. Channel 2 can
only be used for the temperature probe. If you
choose not to use the temperature probe, channel
2 will display “---“.
5. Insert the batteries in the second transmitter as
soon as the outdoor temperature readings from the
first transmitter are displayed on the Temperature
Station.