Datasheet

33
Temperature Station will start receiving data
signal from the transmitter. The outdoor
temperature data (channel 1 and 2) should
then be displayed on the Temperature
station. If this does not happen after 2
minutes, the batteries will need to be
removed from both units and reset from step
1.
4. In order to ensure sufficient 868 MHz transmission
however, the distance between the Temperature
Station and the transmitter should not be more than
100 meters (see notes on “Positioning” and “868
MHz Reception”).
Note:
In the event of changing batteries of the units, ensure the
batteries do not spring free from the contacts. Always wait
at least 1 minute after removing the batteries before
reinserting, otherwise start up and transmission problems
may occur.
OPTIONAL CHANNEL 2 TEMPERATURE
PROBE
When the temperature probe is connected to the
temperature transmitter, the temperature station will
always display the outdoor temperature transmitter data in
channel 1, and the temperature recorded from the probe
in channel 2.
If the probe on remote temperature sensor is
unplugged, the "probe channel" will show "---", the
temperature data from the transmitter will still be
displayed.
The temperature probe can be connected to the
temperature transmitter anytime. There is no need to
reset the units. The Temperature Station will automatically