Datasheet

43
MANUAL TIME SETTING
In case the Temperature Station is not able to detect the
DCF-signal (disturbances, transmitting distance, etc.), the
time can be manually set. The clock will then work as a
normal Quartz clock.
To set the clock:
1. The hour and minutes digits start flashing in the
time display section.
2. Use the IN key to adjust the hours and the OUT
key to adjust the minutes. If you hold the key while
you adjust, the hours move 1 hour and the minutes
move 5 minutes.
3. Confirm with the SET key and enter the “Calendar
Setting” or exit the setting mode by pressing the
CH key
Note:
The unit will still try and receive the signal despite it being
manually set. When it does receive the signal, it will
change the manually set time into the received time.
During reception attempts the DCF tower icon will flash. If
reception has been unsuccessful, then the DCF tower
icon will not appear but reception will still be attempted the
following day.
Minutes
(flashing)
Hours
(flashing)