Instructions

3130
Radio-controlled projection alarm clock with thermometer

Radio-controlled projection alarm clock with thermometer

9.1 Battery replacement
• Change the batteries when the device functions become weak (in battery operation).
• Open the battery compartment and insert two new AA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.
10. Troubleshooting
Problem Solution
No display Battery operation:
➜ Ensure the batteries' polarities are correct
➜ Change the batteries
Operation with power adapter:
➜ Control the power adapter
No projection ➜ Press the SNOOZE/LIGHT button
Operation with power adapter:
➜ Activate with Projection HIGH/LOW/OFF button
No backlight ➜ Press the SNOOZE/LIGHT button
8.1 Projection
• The projection of the time (DCF), indoor temperature and alarm symbol (if alarm is activated) appears
onto a wall or ceiling.
• Press the Projection HIGH/LOW/OFF button to adjust the brightness in 2 levels or to switch it off.
• Press and hold the Projection HIGH/LOW/OFF button to turn the image by 180°.
• Turn the dial and set the focus.
8.2 Backlight
• Press the ▲ or ▼ button to adjust the brightness in 2 levels or to switch it off (HIGH/LOW/OFF).
8.3. SNOOZE/LIGHT button
• To temporarily activate the bright backlight and projection, press the SNOOZE/LIGHT button (in battery oper-
ation or with adapter at the position LOW/OFF).
9. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries and pull out the plug of the socket if the device will not be used for an extended
period of time.
• Keep the device in a dry place.
TFA_No. 60.5016_Anleitung 18.04.2019 13:06 Uhr Seite 16