Instructions

3534
SHOW – Radio-controlled projection clock with indoor climate

SHOW – Radio-controlled projection clock with indoor climate

• When the adjusted alarm time is reached, the alarm rings.
• Press any button (except SNOOZE/LIGHT) and the alarm will stop.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after two minutes and it will be reactivated at
the same set time on the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE/LIGHT button and the snooze function is activated.
• SNOOZE appears and the alarm will be interrupted for the set time.
• The time display counts down.
• Press any button (except SNOOZE/LIGHT) to turn off the snooze function.
8. Projection and light
• Attention: Continuous illuminated backlight and projection only works when using the power adapter.
• To change the brightness of the backlight (5 levels), press SNOOZE/LIGHT button.
• Press the groove and fold out the projector arm (180°).
• Press the FLIP button to adjust the brightness of the projection in 5 steps.
• Press and hold the FLIP button to turn the image by 90°.
7.2.4 Snooze function setting
• You can set the snooze interval in the setting mode.
• Press the + or – button to set the desired time duration – it adds 5 minutes at a time (5 to 120 minutes).
7.3 Alarm time setting
• Press the ALARM button in normal mode to enter the alarm mode.
• ALARM and 6:30 (default) or the last adjusted alarm time appear on the display.
• Press and hold the ALARM button for three seconds to enter the setting mode.
• The hour digits flash.
• Press the + or – button to adjust the hours.
• Confirm the setting with the ALARM button.
• Set the minutes in the same way.
• Confirm the setting with the ALARM button.
• To activate and deactivate the alarm function press the ALARM button in normal mode.
• The alarm symbol appears/disappears on the display.
TFA_No. 60.5014_Anleitung 17.07.2018 13:28 Uhr Seite 18