Instructions

2524
CLOCCO – Wood style radio-controlled alarm clock with large LED digits

CLOCCO – Wood style radio-controlled alarm clock with large LED digits

• Confirm with the SET button.
• To activate the alarm function slide the ALARM switch to ON.
• The alarm symbol appears on the display.
• When the adjusted alarm time is reached, the alarm rings.
• Press any button to stop the alarm.
• If the alarm is not stopped manually, the ascending alarm tone auto-
matically turns off after 3 minutes and it will be reactivated at the same
set time on the following day.
• The alarm symbol remains on the display.
• To deactivate the alarm function slide the ALARM switch to OFF. The
alarm symbol disappears.
8. Display light
8.1 Operation with power adapter
• Attention: Continuous illuminated display only works when using the
power adapter.
• To change the brightness of the display (3 levels), press the DOWN but-
ton (L1=strong, L2=middle, L3=weak).
• If the automatic dimming function is activated (A-on), the weak backlight
(brightness level L3) turns on automatically between 19:00 and 6:59 am.
8.2 Battery operation (power-saving mode)
• To activate the display, touch the alarm clock or make a loud sound
(such as clapping your hands).
• The display turns on for 15 seconds.
9. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scour-
ing agents.
7.1.1.1 Display mode
• Each press on the UP button in normal mode will change the display
between: Time, date or indoor temperature.
• d-1: In this mode the last selected display is permanently active.
• d-2: After 10 seconds, the display automatically reverts to the
clock mode.
• d-3: Time, date and indoor temperature in sequence
7.1.1.2 Automatic dimming function
• By default, the automatic dimming function is disabled (A-of).
• If the automatic dimming function is activated (A-on), the weak back-
light (brightness level L3) turns on automatically between 19:00 and
6:59 am (see ”Display light”).
7.1.1.3 DCF reception
• By default, the DCF reception is activated (dCF 1) and after successful
reception of the DCF signal no manual adjustment is necessary.
• Press the UP or DOWN button if you want to deactivate the DCF recep-
tion (dCF 0).
• Once the DCF time reception is deactivated the clock and date must be
manually set.
7.1.2 Alarm time setting
• Press the SET button in normal mode to enter the setting mode.
• 6:00 (default) or the last adjusted alarm time appear on the display.
• The hour digits flash.
• Press the UP or DOWN button to adjust the hours.
• Confirm with the SET button.
• Set the minutes in the same way.
TFA_No. 60.2549_Anleitung_10_21 18.10.2021 14:35 Uhr Seite 13