Instructions

2120
CLOCCO – Wood style radio-controlled alarm clock with large LED digits

CLOCCO – Wood style radio-controlled alarm clock with large LED digits

C 3: Battery compartment 3 x 1,5 V AAA
C 4: Battery compartment cover
C 5: Power adapter jack
6. Getting started
• The alarm clock can be operated with the 3 x 1,5 V AAA batteries (not
included) or with the supplied power adaptor.
• For a permanent display light and to conserve battery power, use the
supplied power adapter.
• The CR2032 button cell (included) is a back-up battery to keep the
clock operational in the event of a blackout or other power failure.
• Open the alarm clock's battery compartment.
• Remove the battery interruption strip for the button cell battery in the
inner battery compartment (screwed).
• Optional: Insert three new AAA 1.5 V batteries, polarity as illustrated.
• Close the battery compartment again.
• Insert the power adapter pin into the device jack and connect the plug
to a wall socket.
• Important! Make sure that your household voltage is no more than
240V! Otherwise your device may be damaged.
• A beep tone is heard and 0:00 appears on the display.
6.1 Reception of the DCF frequency signal
• Press and hold the DOWN button for 2 seconds. The clock will now scan
the DCF frequency signal and the DCF symbol flashes.
• To avoid interference, the backlight turns off during the reception of the
radio-controlled clock.
• When the time code is successfully received after 2-12 minutes, the
radio-controlled time and the DCF symbol will be shown steadily on the
display.
• To end the DCF reception attempt, press the DOWN button again.
• Batteries must not be thrown into a fire, short-circuited, taken apart or
recharged. Risk of explosion!
• Low batteries should be changed as soon as possible to prevent dam-
age caused by leaking.
• Never use a combination of old and new batteries together, nor batter-
ies of different types.
• Avoid contact with skin, eyes and mucous membranes when handling
leaking batteries. In case of contact, immediately rinse the affected
areas with water and consult a doctor.
 Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or
shocks.
• Do not place any objects on the unit.
• Protect it from moisture!
5. Elements
5.1 Display (Fig. 1)
A 1: Alarm symbol
A 2: DCF Reception symbol
A 3: Time/date/indoor temperature
5.2 Buttons (Fig. 1)
B 1: SET button
B 2: UP button
B 3: DOWN button
B 4: ALARM switch
5.3 Housing (Fig. 2)
C 1: Battery compartment CR2032
C 2: Inner battery compartment cover
TFA_No. 60.2549_Anleitung_10_21 18.10.2021 14:35 Uhr Seite 11