Instructions

2322
SIESTA – Radio-controlled alarm clock

A 4: Alarm time display with alarm symbol
A 5: Temperature dispaly with backlight symbol
B: Buttons:
B 1: Switch setting time and alarmtime, ALARM ON/OFF
B 2: CLEAR button
B 3: HR button
B 4: 5 and 15 and 30 button
B 5: MIN button
B 6: SNOOZE/LIGHT button
C: Housing:
C 1: Battery compartment
6. Getting started
• Open the battery compartment and insert two new batteries 1.5 V AA, polarity as illustrated.
• Close the battery compartment again.
SIESTA – Radio-controlled alarm clock

• The device will alert you with a beep and all segments will be displayed for a short moment.
• The indoor temperature (default °C) appears on the display. It may take 3-8 minutes until the correct temperature is dis-
played.
6.1 Reception of the radio controlled time
• Attention: The radio reception only works in normal mode (switch to position AL ON / OFF)
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display. When the time code
is received successfully after 7 minutes, the radio-controlled time and the DCF symbol are displayed steadily on the dis-
play.
• The DCF reception always takes place daily at 1:00, 2:00, 3:00, 4:00 and 5:00 o'clock in the morning. If the reception is
not successfully received until 5:00 o'clock, the next receive operation is again at 1:00 o'clock in the morning.
• You can start the initialization manually.
• Press and hold HR button for three seconds.
• The DCF reception symbol will be flashing.
• To end the DCF reception attempt, press the HR button short. The DCF reception symbol disappears.
TFA_No. 60.2532_anl_01_16 25.01.2016 15:45 Uhr Seite 12