Manual

– 26 – – 27 –
Digital alarm clock and night light

• Do not expose the device to extreme temperatures, vibrations or shocks.
• The instrument is not unbreakable. In case of falling down parts can break.
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
4. Elements
A: LCD display (Fig. 1):
A 1: Date A 2: Day of the week
A 3: Night light symbol A 4: Charging status symbol
A 5: Night light AUTO-OFF A 6: Time
A 7: Indoor temperature A 8: Alarm symbol 2
A 9: Alarm symbol 1 A 10: Snooze symbol
B: Buttons (Fig. 2+3):
B 1: SNOOZE/LIGHT sensor button B 2: + button
B 3: – button B 4: ALARM button
B 5: SET button
C: Housing (Fig. 2+3):
C 1: Night light C 2: Ventilation slots
C 3: Micro USB port C 4: 4 rubber feet
5. Getting started
• Remove the protective film from the display.
• Plug the supplied USB cable into the designated port on the device and connect the unit to the mains using the
power adapter.
Digital alarm clock and night light

• Do not apply excessive force when connecting the USB cable. The USB plug fits only one way into the USB port.
• The instrument turns on.
6. Charging
• Before the first use, please charge it fully.
• When using the mains adapter as a power source, the integrated Li-Ion battery is charged. To fully charge, leave
the device connected for approximately 6 hours. The charging status symbol (segment A) flashes during charg-
ing.
• When the device is fully charged, the charging status symbol will appear filled (segment A + B).
• If you operate the device without a power connection, the battery runtime is about 15-20 days (without night
light).
• The charging status of the device is shown on a symbol with two segments. If the battery voltage is below 50 %,
segment A disappears.
• Segment B flashes, when the battery needs to be charged (battery voltage below 20%).
• Please charge the device immediately to preserve battery life.
• Recharge the battery every six months, even if the device is not in use.
• Please switch off the device (hold and press + and – button at the same time) if not using it for a long time.
7. Operation
7.1 Display light
• To save energy, the display fades out automatically after 7 seconds (completely extinguished after 10 seconds)
if the device is not connected to the mains. The display remains permanently active when you leave the unit
connected.
• To temporarily activate the display, touch the alarm clock slightly or make a loud sound (such as clapping your
hands). In setting mode and during the alarm, the display light remains on.
TFA_No. 60.2034_Anleitung 25.05.2022 13:59 Uhr Seite 14