Instructions

2120
Digital alarm clock with LED digits

• Open the alarm clock's battery compartment. Insert three new AAA 1.5 V batteries, polarity as
illustrated. Close the battery compartment.
• For a permanent display light and to save battery life, use the supplied DC 5V USB cable.
• Connect the attached power adapter to the alarm clock. Important! Make sure that your house-
hold voltage is no more than 240V! Otherwise your device may be damaged.
• A beep tone is heard and 00:00 appears on the display.
• The device is ready for use.
7. Settings
• Press and hold the + or – button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is pressed for 10 seconds.
7.1 Time setting
• Press and hold the TIME button in normal mode for three seconds.
• The hour digit will be flashing. Press the + or – button to adjust hours.
• Confirm the setting with the TIME button.
• Set the minutes in the same way.
• Confirm with the TIME button.
Digital alarm clock with LED digits

7.2 Alarm time setting
• Press the ALARM button in normal mode, to show the alarm time. The alarm symbol flashes.
• Press and hold the ALARM button for 3 seconds.
• 6:00 (default) or the last adjusted alarm time appear on the display.
• The alarm symbol and the hour digit are flashing. Press the + or – button to set the hours.
• Confirm the setting with the ALARM button.
• Set the minutes in the same way.
• Confirm the setting with the ALARM button. The display shows the current time.
• To activate/deactivate the alarm function, move the ALARM ON/OFF switch to ON or OFF.
• The alarm symbol appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached.
• Press any button (except SNOOZE) and the alarm will stop.
• If the alarm is not stopped manually, the alarm tone automatically turns off after one minute and
will be reactivated at the same set time in the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE sensor button briefly and the snooze function is acti-
vated. The snooze symbol flashes on the display.
• The alarm will be interrupted for 5 minutes.
• Press any button (except SNOOZE) and the snooze function will stop.
TFA_No. 60.2027_Anleitung 07.06.2020 9:16 Uhr Seite 11