Instructions

1110
WIND BEE - Anemometer

• All LCD segments will be displayed for about a few se-
conds.
• The battery symbol, the actual measured temperature,
the measuring unit (default: m/s) and 000:0 appear on
the display.
• The unit is ready for use.
• The device will turn off automatically after 15 minutes,
if no button is pressed.
• Press the ON/OFF button for at least 3 seconds to turn
off the instrument immediately.
6.2 Measuring of the wind speed
• Press the ON/OFF button.
• All LCD segments will be displayed for about a few se-
conds.
• The battery symbol, the actual measured temperature,
the measuring unit (default: m/s) and 000:0 appear on
the display.
• Press and hold the MAX/MIN button to change
between m/s, km/h, Knots, Mph or ft/min as measur-
ing unit.
• Hold the device in the wind.
• The wind speed is displayed in the selected measuring
unit.
6.3 Reading of the maximum and minimum values
• Press the MAX/MIN button to enter the maximum and
minimum mode.
• MAX appears on the display.
• The highest wind speed and the temperature since the
last activating of the device are displayed.
• Press the button again.
• MIN appears on the display.
• The lowest wind speed and the temperature since the
last activating of the device are displayed.
• Press the MAX/MIN button again to leave the maxi-
mum and minimum mode
WIND BEE - Anemometer

Caution!
 Risk of injury:
• Keep this instrument and the battery out of the reach
of children.
• Batteries must not be thrown into a fire, short-circuit-
ed, taken apart or recharged. Risk of explosion!
• Batteries contain harmful acids. Low batteries should
be changed as soon as possible to prevent damage
caused by leaking.
• Wear chemical-resistant protective gloves and safety
glasses when handling leaking batteries.
 Important information on product safety!
• Do not place your product near extreme temperatures,
vibrations or shocks.
• Protect it from moisture, sand, dirt and dust.
5. Elements
Buttons
ON/OFF button (front)
MAX/MIN button (laterally)
Housing (back)
Tripod screw
Battery compartment (screwed)
6. Operation
6.1 Getting started
• Open the screw of the battery compartment (below
RoHS sign) and insert the battery 9 V. Ensure that the
battery polarity is correct.
• Please pay attention to the connection wires.
• Close the battery compartment again.
TFA_No. 42.6003 Anleitung_02_17 08.02.2017 14:33 Uhr Seite 6