Instructions

29
POSITIONING THE WEATHER STATION:
The weather station provides the option of table standing or wall mounting. Before wall
mounting, please check that the outdoor data can be received from the desired
locations.
To wall mount:
1. Fix a screw (not supplied) into the desired wall, leaving the head extended out by
about 5mm.
2. Place the weather station onto the screw, using the hanging hole on the backside.
Gently pull the weather station down to lock the screw into place.
Foldout table stand:
The foldout table stand leg is located on the backside. Pull the stand out. Once the foldout table stand is
extended, place the weather station in an appropriate location.
POSITIONING THE THERMO-HYGRO TRANSMITTER:
Mounting at a sheltered place. Avoid direct rain and sunshine.
The thermo-hygro transmitter can be placed onto any flat surface or wall mounted using the
bracket which doubles as a stand or wall mount base.
To wall mount:
1. Secure the bracket onto a desired wall using the screws and plastic anchors.
2. Clip the transmitter onto the bracket.
Note:
Before permanently fixing the thermo-hygro to the wall base, pace all units in the desired locations
to check that the outdoor temperature and humidity readings are receivable. In event that the
signal is not received, relocate the thermo-hygro transmitter or the weather station slightly as this
may help the signal reception.
CARE AND MAINTENANCE
 Clean the instrument and the transmitter with a soft damp cloth. Do not use solvents or scouring
agents. Protect from moisture.
 Remove the batteries if you do not use the product for a lengthy period.