Instructions

LOG10 – Data logger

LOG10 – Data logger

1514
I: MAX-MIN-AVG
display the average, minimum or maximum measurements.
J: Status info
displays the operation mode LOG or STOP. LOG indicates the recording
mode and STOP indicates standby mode.
K: Lowbat
indicates the capacity of the battery.
Note:
°C = Celsius,°F = Fahrenheit
Other display information
• In addition to the above mentioned information, the display also indicates
several other information. This information will be displayed depending
on the display settings (snooze function) and operation mode:
Display connected Logger
switched off to the PC configured
Logger Battery Factory settings
is recording (total empty)
• MAX-, MIN-, Average values:
At the bottom line of the display, you will see the Average (AVG)-, Minimum
(MIN)- and Maximum (MAX) temperature of the recorded measurements. If
the data logger is not started it will display --- instead of AVG, MIN or MAX
temperature.
AVG: MIN: MAX: AUT:
Average Minimum Maximum Auto-switch
The display will switch automatically every 10 seconds.
2.4 Display segments of LCD (Fig. 2)
•
Besides the two measurements, the large LCD displays several status informa-
tion. By using the Software DE-LOG-Graph you are able to switch on or off the
display, or to setup an interval how long the display will stay on when no but-
ton is pressed (snooze function). By using this function it is possible to prevent
it displaying information to unauthorized persons.
E: Measurement 1
displays the current temperature.
F: Unit Measurement 1
display the current measuring unit of measurement 1.
G: Measurement 2
displays the temperature measurement, average, minimum or maximum
measurements.
H: Unit Measurement 2
display the current measuring unit of measurement 2.
➥
➥
DE_Log10_Anleitung 22.03.2011 10:27 Uhr Seite 8