Manual

1716
AIR CO
2
NTROL UP Single Beam – CO
2
Monitor

1. Delivery contents
•CO
2
Monitor
• USB-Type-C-1,5 m cable and power adaptor
• Instruction manual
2. Range of application and all the benefits of your new instrument at a
glance
• For monitoring the CO
2
concentration in buildings, where people are
present, eg: schools, offices, public facilities
• Single Beam NDIR Sensor
• Large CO
2
display with extended traffic light indication (green/yellow/
blue/red)
• Display of indoor temperature (°C/°F) and humidity
• Memory of the highest and lowest values of CO
2
, temperature and humi-
dity
• Alarm function for CO
2
concentration
• High contrast display with 4 brightness levels
• Manual calibration function for CO
2
sensor
• Power connection via USB Type-C cable and power supply (included) or
a suitable USB power source
3. For your safety
• This product is exclusively intended for the range of application described
above. It should only be used as described within these instructions.
• Unauthorized repairs, alterations or changes to the product are prohibited.
Caution!
 Risk of electrocution!
• Connect the device using the USB cable and the supplied power supply to
a mains socket installed within your country’s electrical safety regulations
and with a correct mains voltage (see nameplate) or connect the device
via the USB cable to a suitable USB power source such as a computer,
notebook.
• The mains socket must be located near the equipment and it must be
easily accessible.
• Unplug the device immediately if any fault occurs.
• The device and the power adapter must not come into contact with water
or moisture. Only suitable for indoor use.
AIR CO
2
NTROL UP Single Beam – CO
2
Monitor

• Do not use the device if the housing, the USB cable or the power adaptor
are damaged.
• Operate the device out of reach of persons (including children) who can-
not fully appreciate the potential risks of handling electrical equipment.
• Connect the USB cable to the device and the power adaptor first and then
plug the power adapter into the socket.
• Route the USB cable lead so that it does not come into contact with sharp-
edged or hot objects.
 Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
Avoid direct sunshine.
• The instrument is not unbreakable. In case of falling down parts can
break.
4. Elements
A: LCD display (Fig. 1):
A 1: CO
2
alarm limit
A 2: CO
2
indication
A 3: Display of minimum values
A 4: CO
2
value > 2000 ppm
A 5: Extended traffic light indication
A 6: Indoor temperature and humidity
A 7: CO
2
alarm symbol
A 8: Display of maximum values
B: Buttons (Fig. 1+2):
B 1: POWER/LIGHT sensor button
B 2: DOWN/CALIBRATE button
B 3: MEM button
B 4: CO
2
SET button
B 5: CO
2
ALARM button
B 6: UP/°C/°F button
B 7: RESET button
C: Housing (Fig. 3):
C 1: USB port
TFA_No. 31.5011_Anleit_10_22 18.10.2022 10:40 Uhr Seite 9