Instructions

1514
Digital thermo-hygrometer

A 6: Indoor humidity
A 7: Indoor temperature
A 8: Outdoor temperature
B: Buttons (Fig. 2):
B 1: set button
B 2: minmax button
B 3: + button
C: Housing (Fig. 2):
C 1: Wall mounting hole
C 2: Stand (fold out)
C 3: Battery compartment
C 4: Sensor cable
6. Operation
• Press and hold the + button in the respective setting mode for
quick setting.
• The device will automatically quit the setting mode if no button
is pressed for 20 seconds.
7. Getting started
• Remove the protective film from the display.
• Open the battery compartment and insert two new AAA 1.5 V
batteries, polarity as illustrated.
• Close the battery compartment again.
• All segments will be displayed briefly.
• The device is ready for use.
8. Setting mode
• After batteries are inserted or by holding the set button for
2 seconds, the hour digits will be flashing (0:00) for 20 seconds.
Digital thermo-hygrometer

• Press + button to adjust hours.
• Press the set button again to make the settings in the following
sequence: the minutes, the temperature unit (°C - default), the
reset mode of the maximum-minimum values (manual - default)
and adjust it with the + button.
• Confirm the setting with the set button.
8.1 Temperature display
• In the setting mode you can change between °C (Celsius) or °F
(Fahrenheit) as temperature unit.
• If you set Fahrenheit as temperature unit the time will be shown
automatically in 12 hours system. AM or PM appears on the dis-
play.
8.2 Reset of the maximum-minimum values
• Press the + button in the setting mode to select the automatic
(auto) or manual reset mode of the maximum-minimum values.
8.2.1 Manual reset mode
• To clear the recorded maximum or minimum readings, press
and hold the minmax button for three seconds while the maxi-
mum or minimum values are displayed.
8.2.2 Automatic reset mode
• The maximum and minimum values are automatically reset at
midnight. Manual reset is also possible (see 8.2.1).
9. Indication of maximum and minimum values
•
Press the minmax button.
• min appears on the display.
TFA_No. 30.5048_Anleitung 14.09.2018 11:35 Uhr Seite 8