Manual

– 24 – – 25 –
Wireless thermometer

A 17: Time
A 18: Day of the week
A 19: Date
B: Buttons (Fig. 2):
B 1: SET button
B 2: -/MIN button
B 3: MAX/+ button
B 4: ALARM button
C: Housing (Fig. 2-3):
C 1: Stand (fold out)
C 2: Wall mounting hole
C 3: Battery compartment
C 4: 2 magnets
Transmitter 1 (with cable)
D: Display (Fig. 4):
D 1: Channel 1/2/3
D 2: Transmission signal
D 3: Battery symbol for the transmitter
D 4: Temperature
E: Housing (Fig. 4):
E 1: Battery compartment
E 2: Support for wall mounting or table standing
E 3: Indentations for the holder for wall mounting
E 4: Cable sensor (firmly connected)
F: Buttons in the battery compartment (Fig. 4):
F 1: TX button
F 2: 1 2 3 switch for channel selection
Transmitter 2
As transmitter 1 (without cable)
Wireless thermometer

6. Getting started
6.1 Insert the batteries
• Place the instruments on a table at a distance of
about 1.5 meters from each other. Avoid being close
to possible sources of interference such as electron-
ic devices and radio equipment.
• Open the battery compartment of transmitter 1 (with
cable) and insert two new AA 1.5 V batteries, polari-
ty as illustrated. All LCD segments will be displayed
for a short moment. The display shows the tempera-
ture. The switch is set to channel 1.
• Close the battery compartment.
• Repeat the process for transmitter 2. The switch is
set to channel 2.
• Open the battery compartment of the base station.
• Insert two new AAA 1.5 V batteries, polarity as illus-
trated. The device will alert you with a beep and all
LCD segments will be displayed for a short moment.
• Close the battery compartment.
6.2 Transmitters reception
• The base station will scan the measuring values of
both transmitters. The reception symbols flash on the
display.
• If the reception is successful, the temperature val-
ues of transmitter 1 and 2 and the reception sym-
bols appear steadily on the base station display.
• If the reception of the temperature fails, “- -,-”
remains on the display. Check the batteries and try it
again.
• You can also activate the reception manually. Hold
the MAX/+ button on the base station for 5 seconds.
The reception symbols for the transmitters are
flashing.
• Press the TX button in the transmitters' battery
compartment. The transmission of the data takes
place immediately and if the reception is successful,
the temperature values appear on the base station
display.
TFA_No. 30.3073_Anleit_kurz 23.11.2022 11:36 Uhr Seite 13