Instructions

2322
PALMA – Wireless pool thermometer

• You can also start the search for the transmitter manually. Choose
with the CH button on the base station the corresponding channel
and press und hold the CH button for three seconds. “- - ,- °C”
appears on the lower display. The reception symbol for the transmit-
ter flashes.
• Press the CH button on the base station to display sequentially the
outdoor values for the desired transmitters. Press the CH button
again after the last registered channel and a circle symbol will
appear. On the lower display the values of the installed transmitters
are displayed in sequence. To deactivate the function press the CH
button again.
• With the MAX/MIN button you can recall the highest and lowest tem-
perature values for all installed transmitters.
10. Care and maintenance
• Clean the devices with a soft damp cloth. Do not use solvents or
scouring agents.
• Remove the batteries if you do not use the devices for a long period
of time.
10.1 Battery replacement
• Change the base station batteries, when the battery symbol appears
on the display of the indoor temperature.
• Change the batteries of the pool sensor, when the battery symbol
appears on the lower display next to the pool temperature.
• Please note:
When the batteries are changed, the contact between the transmitter
and the base station must be restored – so always insert new batter-
ies into both devices or start the manual search for the transmitter.
11. Troubleshooting
Problem Solution
No indication on ➜ Ensure the batteries' polarities are
the base station/ correct
pool sensor ➜ Change the batteries
PALMA – Wireless pool thermometer

No reception ➜ No pool sensor installed
of the pool sensor ➜ Check the batteries of pool sensor
Display “---” (do not use rechargeable batteries!)
➜ Restart the pool sensor and the base
station according to the manual
➜ Start the manual search for the pool
sensor: Press and hold the CH button
on the base station
➜ Choose another place for the base
station
➜ Reduce the distance between the
pool sensor and the base station
➜ Check if there is any source of inter-
ference
Incorrect display ➜ Change the batteries
on the base station
Incorrect display ➜ Wait a few minutes
on pool sensor
immediately after assembly
Indication: LL.L / HH.H ➜ Outside measuring range
If your device fails to work despite these measures, contact the retailer
where you purchased the product.
12. Waste disposal
This product has been manufactured using high-grade materials and
components which can be recycled and reused.
Never dispose of empty batteries and rechargeable batter-
ies with ordinary household waste.
As a consumer, you are required by law to take them to
your retail store or to an appropriate collection site
depending on national or local regulations in order to pro-
tect the environment.
The symbols for the contained heavy metals are:
Cd = cadmium, Hg = mercury, Pb = lead
TFA_No. 30.3067_Anleitung 21.12.2018 11:45 Uhr Seite 12