Instructions

1918
PALMA – Wireless pool thermometer

B: Buttons (Fig. 1):
B 1: °C/°F button B 2: CLEAR button
B 3: CH button B 4: MAX/MIN button
C: Housing (Fig. 2):
C 1: Wall mounting hole C 2: Battery compartment
C 3: Stand (fold out)
5.2 Pool sensor (Fig. 3):
D 1: Display D 2: Lid
D 3: Body D 4: Fastening rope
5.2.1 Pool sensor (Fig. 4):
D 5: Screw cover
D 6: Transparent lid
D 7: Silicone sealing ring
D 8: LCD display
D 9: Battery container
D 10: Body
D 11: Temperature sensor
D 12: °C/°F switch
D 13: CH switch for channel selection
6. Getting started
6.1 Insert the batteries
• Place the instruments on a table at a distance of about 1.5 meters
from each other. Avoid being close to possible sources of inter-
ference such as electronic devices and radio equipment.
6.2 Installation of the base station
• Remove the protective film from the display.
• Open the battery compartment and insert two new AAA 1.5 V batte-
ries, polarity as illustrated.
• All segments will be displayed briefly.
PALMA – Wireless pool thermometer

• On the upper display of the base station appears the indoor tempera-
ture.
• On the lower display appears “- - ,- °C”.
• The reception symbol for the pool sensor flashes. The base station
will scan for 3 minutes the outdoor values. You can install the pool
sensor during this time.
• Close the battery compartment again.
6.3 Installation of the pool sensor
• Open the cover in the direction of the arrow and remove the display
element.
• Carefully pull the battery container out of the body and insert 2 x AAA
1.5 volt batteries with the correct polarity.
• Push the battery container back into the housing. Insert the double-
sided aids into the slots.
• The °C/°F switch and the CH switch for channel selection are located
on the circuit board on the back of the display.
• Use the °C/°F switch to change between °C (Celsius) or °F (Fahren-
heit) as temperature unit (default °C).
• The switch for channel selection is at position 1 (default).
TFA_No. 30.3067_Anleitung 21.12.2018 11:45 Uhr Seite 10