Instructions

This output has two switching outputs that react as follows in case of an

alarm on channel 1.

Switch point 1, active when the temp. or rH is exceeded on channel 1.

Switch point 2, active when the temp. or rH is undershot on channel 1.

A switch point is active as long as the alarm limit is triggered and

deactivated again as soon as the respective value is again within the

standard range or the respective alarm setting is deactivated.

The open collector output has a jack for a 3.5 mm jack plug. The

following drawing shows the configuration.

Technical specifications:

Maximum switching voltage: 24V. DC

Maximum switching current: 400 mA

Note:

Comply with the technical specifications.

Jack

switch point 1

- high alarm -

switch point 2

- low alarm -

C = switch point 1, high alarm

B = switch point 2, low alarm

A = ground