Instructions

39
individual name to each channel (except for the logger’s own
measured values. The name “INDOOR” is always displayed with
these values.)
Note:
If you do not know for certain which transmitter is entered for which
channel in your individual channel designations, you can call up this
information in learning mode. In learning mode, the serial number of the
entered channel is always displayed for the corresponding channel.
In the channel display, a status information symbol can be displayed for
every transmitter. It is a bar that is displayed under the channel number.
If the bar flashes, the batteries of the corresponding transmitter are weak
and should be replaced (in this case, a “TX” symbol also appears in the
temperature display area when the corresponding channel is
selected/displayed). If a bar is displayed constantly, radio contact to the
corresponding transmitter has been interrupted.
Note:
After the batteries of a transmitter are changed, we recommend
activating the comprehensive transmitter search in learning mode in
order to re-establish contact as quickly as possible.
A transmitter can be entered into a receiving device for only three hours
after it is started up. The transmitter then only transmits its current
measured values and can no longer be entered on a receiving device.
LEARNING MODE:
Learning mode allows you to manually start a transmitter search. It is
possible to enter a transmitter individually on every channel. Furthermore
a transmitter that was already entered can be removed.
 Press SET button to enter setting mode.
 CH1-8 and LRN appear in the display.
 The channel numbers start flashing.
 If a transmitter is already entered on a channel, a triangle is
displayed above the corresponding channel number.
Comprehensive channel search
 Press and hold the OK/MAX/MIN button for 3 seconds to
start a comprehensive transmitter search. Drücken um eine
übergreifende Sendersuche zu starten.
 LEARNING and the channel numbers appear on the display