Instructions

reset to factory settings. After the “OK/MAX.MIN.” button has been

pressed and held for three seconds, the progress of the reset is

shown in % on the memory display. The KlimaLogg Pro

automatically restarts when the reset is complete.

Note:

Note that through the main reset also all recorded data will deleted. If

necessary, please ensure that there is no relevant data on the

KlimaLogg Pro that has not yet been retrieved or transferred to the PC.

If the device shows a malfunction, we recommend that you firstly check

the batteries and try a normal reboot of the unit. If this does not help, we

recommend that you do the main reset.

TRANSMITTERS:

•

If you use your logger with additional transmitters that were entered

into the logger during startup or via the learning mode, you see a

number in the channel display for every assigned channel.

•

After inserting the batteries in to the transmitter, the transmitter

automatically starts transferring the outdoor values.

•

After successful start up of the transmitter close the battery

compartment carefully.

•

In the normal view and as well as in history mode, you can scroll

up and down through the existing channels by pressing the + or -

button. A triangle is displayed above the currently selected channel

symbol, and the current channel values are displayed in the

temperature and humidity display area.

•

The compatible external transmitters (Kat.Nr. 30.3180.IT and

30.3181.IT) each have their own predefined serial numbers (four-

digit, alphanumeric). This serial number is printed on the respective

transmitter and is also briefly displayed on the transmitter’s display

when it is started up. The serial number is also displayed on the

text display (if the transmitter has been selected as the current one

on the KlimaLogg Pro). The PC software allows you to assign an

individual name to each channel (except for the logger’s own

measured values. The name “INDOOR” is always displayed with

these values.)

Note:

If you do not know for certain which transmitter is entered for which

channel in your individual channel designations, you can call up this