Instructions

38
POSITIONING THE THERMO-HYGRO-STATION
The thermo-hygro-station provides the option of table standing or wall
mounting the unit. Before wall mounting, please check that the outdoor
data can be received from the desired locations.
To wall mount:
1. Fix a screw (not supplied) into the desired
wall, leaving the head extended out by about
5mm.
2. Place the thermo-hygro-station onto the
screw, using the hanging hole on the
backside. Gently pull the thermo-hygro-station
down to lock the screw into place.
POSITIONING THE THERMO-HYGRO TRANSMITTER
The thermo-hygro transmitter
can be placed onto any flat
surface or wall mounted using
the bracket which doubles as a
stand or wall mount base.
To wall mount:
1. Secure the bracket onto
a desired wall using the
screws and plastic
anchors.
2. Clip the transmitter onto
the bracket.
Note:
Before permanently fixing the remote temperature/humidity sensor wall
base, pace all units in the desired locations to check that the outdoor
temperature and humidity readings are receivable. In event that the signal
is not received, relocate the remote temperature/humidity sensor or move
them slightly as this may help the signal reception.
CARE AND MAINTENANCE
• Clean the instrument and the transmitter with a soft damp cloth. Do
not use solvents or scouring agents. Protect from moisture.
Table stand/wall
mount bracket