Operation Manual

Replacement the trimmer cord

Fig.4

1. Press on each side of the line compartment. The lid may now be removed.

2. Dismount the roll simply by pulling it. Leave the spring on the spool. Remove any bits of line.

3. Take 3-4 meters of new line (2,4 mm) and place it double in a loop-

4. Fit the loop in the middle of the spool and wind the nylon lines around the spool in each groove

without twisting the line. Follow the direction of the arrows from bottom of the spool.

Do not overfill the spool!

5. Mount the line compartment in reverse order. First, fit the spring into its position. Then place the line

in the two metal mortises of the line compartment.

6. Mount the lid. Ensure that it is fitted securely. Cut of excess nylon line.

Operation

 For moving the line forward you tap the trimmer head lightly against the ground while the engine

runs at full speed.

 Hold the trimmer at an upright angle towards the area that is to be cut.

 Stones and walls, and poles cause the line to be worn down very fast.

 Small trees and bushes can be easily damaged by the brush cutter.

Start / Stop.

How to start

See fig. 6

1. Press and hold the button

2. Press and hold the button

How to stop the engine

1. Release all buttons.

Vibrations may travel up into the handle

during use. We therefore recommend taking

a break every 2 hours.

Storage

Storage the product in a dry environment. It is recommended to hang the product on a wall, ensuring it is not

supporting on any of the attachment tools.

Lubrication of hedge trimmer accessory

The gearbox is lubricated from the factory, but for every 30-hour operation Grease MUST be refilled. Top up

with grease type: MULTIFAK EP-0 using a grease gun (not included) on the lubrication nipple.

Texas part no. 90306500.

Please note that the gearbox must be lubricated at all-time (all parts)

The blades must be kept lubricated to prevent friction and to extend the durability. Lubricate the blades with

regular hedge trimmer oil.

Lubricating the chain on the chainsaw accessory

 Let the chainsaw run idle for 2-3 min.

 Place saw on a flat surface

 Remove the lid.

 Add chain oil in the chainsaw container (top up).