Operation Manual

www.texas.dk
9
Assemble the machine
Height Adjustment
Height adjustment: The MCP 1300 has 3 different settings.
Pull the lever on the left side (see illustration) and set the
desired height. Release the handles and put into place when
setting development is found.
Depending on the hardness, for example, after a long
drought period when the lawn is very hard, it is recommend-
ed to start in the middle height to avoid damage on the ma-
chine. Then you can run over the lawn once in lowest posi-
tion.
The lowest setting is used to thoroughly get to the bottom.
The middle setting is used for a moderate treatment of the lawn.
The highest setting is used to provide an easy treatment. It can also be used to remove
grass clippings and leaves from the lawn.
1
Fit the lower handlebar to machine and
secure with screw.
4
Attach the cable and secure with screw.
Adjust wires and fit.
2
Fit Center handlebar and secure with butter-
fly knob.
5
Open the ejector flap and insert the
collector box
3
Fit upper handlebar and secure with butter-
fly knob.