Operation Manual

16
Filling of gasoline - Smoking prohibited!
1. Remove the gasoline cap slowly. Place it on a clean surface.
2. Carefully pour the oil mixed fuel into the tank. Beware of spilling.
3. Remount the gasoline cap properly.
4. Wipe any spilled fuel.
Notice! Always turn off the engine when refueling. Never add fuel on a running machine. Always let the
engine cool for 2 minutes before refueling. Move more than 3 meters away from the place where you putted
fuel on the engine before it is started.
Safety warnings
! Mix and store the fuel in approved containers. Mix the fuel outdoors where there are no sparks or
flames.
! Choose a suitable place, turn off the engine and leave it to cool for 2 minutes before refueling.
! Remove the gasoline cap slowly in order to ease gasoline fumes pressure from the fuel tank.
! Wipe any spilled fuel. Move more than 3 meters away from the fueling site before starting the
engine.
Air filter
For correct performance and durability the air filter must be kept clean.
1. Remove the lid of the air filter by unscrewing the screw that fastens the lid.
2. Wash the air filter in a lukewarm soap mixture. Leave it to dry. Pour on a little two-stroke oil Press
out any surplus oil. Replace an old and worn filter.
3. Filter and lid is fitted again. Make sure that the filter and lid is securely tightened.
Clean the air filter for every 5 hours or more often if you work in dusty areas.
Spark plug
This machine is equipped with a spark with an electrode distance of 0,6 mm. For optimal performance it
should be replaced once a year.
Storage
1. Empty all fuel from tank.
2. Clean the head, and store the machine frost free and out of reach for children.
3. Observe all safety precautions concerning safe storage and handling of gasoline.
Lubrication of hedge trimmer accessory
The gearbox is lubricated from the factory, but for every 30-hour operation Grease MUST be refilled. Top up
with grease type: MULTIFAK EP-0 using a grease gun (not included) on the lubrication nipple.
Please note that the gearbox must be lubricated at all-time (all parts)
The blades must be kept lubricated to prevent friction and to extend the durability. Lubricate the blades with
Texas hedge trimmer oil part number 90306507 or other manufacturer of hedge trimmer oil.
Lubricating the chain on the pruner accessory
• Let the pruner idle for 2-3 min.
• Place saw on a flat surface
• Remove the lid.
• Add chain oil in the pruner container (top up).
Depending on the conditions you should add chain oil for every 30-45 minutes of use, so check oil
level often. If the pruner is used without chain oil, the chain will be damaged.