Datasheet
Table Of Contents
- XTR108EVM-USB Evaluation Board and Software Tutorial
- 1 Overview
- 2 Hardware Overview
- 3 Hardware Setup
- 3.1 Electrostatic Discharge Warning
- 3.2 Connecting the Hardware
- 3.3 Connecting Power and USB to the USB DAQ Platform
- 3.4 Connecting Loop Power Supply to the XTR108EVM-USB Interface Board
- 3.5 Connecting Outputs to a Digital Multimeter (DMM)
- 3.6 USB DAQ Platform Default Jumper Settings
- 3.7 XTR108EVM-USB Interface Board Default Jumper Settings
- 3.8 XTR108EVM-USB Sensor Board Default Jumper Settings
- 4 Software Setup
- 5 Software Overview
- 6 General Operating Tips
- 7 Hardware Documentation
- 8 Appendix
- Important Notices
Software Overview
www.ti.com
5.6.2 Debug Window
The Debug window, as shown in Figure 31, displays the input and output of all SPI communications. The
command lines follow the syntax of the tioScript mnemonic commands. More information on the
mnemonic commands is available in the Mnemonic Commands section.
Pressing the Clear button clears the strings displayed in the Debug Window until new communications
take place.
Figure 31. Debug Window
5.6.3 About Window
The About window, as shown in Figure 32, lists the version, build date, and author of the currently-
installed version of the XTR108EVM-USB software.
Figure 32. About Window
46
XTR108EVM-USB Evaluation Board and Software Tutorial SBOU123–March 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated