Datasheet
Table Of Contents
- XTR108EVM-USB Evaluation Board and Software Tutorial
- 1 Overview
- 2 Hardware Overview
- 3 Hardware Setup
- 3.1 Electrostatic Discharge Warning
- 3.2 Connecting the Hardware
- 3.3 Connecting Power and USB to the USB DAQ Platform
- 3.4 Connecting Loop Power Supply to the XTR108EVM-USB Interface Board
- 3.5 Connecting Outputs to a Digital Multimeter (DMM)
- 3.6 USB DAQ Platform Default Jumper Settings
- 3.7 XTR108EVM-USB Interface Board Default Jumper Settings
- 3.8 XTR108EVM-USB Sensor Board Default Jumper Settings
- 4 Software Setup
- 5 Software Overview
- 6 General Operating Tips
- 7 Hardware Documentation
- 8 Appendix
- Important Notices
www.ti.com
Software Overview
5.3.7 Verify Calibration
After successfully completing the manual calibration procedure, the minimum-scale, mid-scale, and
maximum-scale Percent Error indicators should be less than or equal to 0.1%. See Figure 26 for an
example of a successful post-calibration screen.
Figure 26. Manual Calibration Tab, Post-Calibration
5.3.8 Reset Calibration
The Reset Calibration button can be clicked at any time in order to cancel the current calibration and
reset the Manual Calibration tab to the initial state. At this point, a new calibration can be performed with
either the current model file or a newly loaded model file.
39
SBOU123–March 2012 XTR108EVM-USB Evaluation Board and Software Tutorial
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated