Datasheet
Table Of Contents
- XTR108EVM-USB Evaluation Board and Software Tutorial
- 1 Overview
- 2 Hardware Overview
- 3 Hardware Setup
- 3.1 Electrostatic Discharge Warning
- 3.2 Connecting the Hardware
- 3.3 Connecting Power and USB to the USB DAQ Platform
- 3.4 Connecting Loop Power Supply to the XTR108EVM-USB Interface Board
- 3.5 Connecting Outputs to a Digital Multimeter (DMM)
- 3.6 USB DAQ Platform Default Jumper Settings
- 3.7 XTR108EVM-USB Interface Board Default Jumper Settings
- 3.8 XTR108EVM-USB Sensor Board Default Jumper Settings
- 4 Software Setup
- 5 Software Overview
- 6 General Operating Tips
- 7 Hardware Documentation
- 8 Appendix
- Important Notices
Software Overview
www.ti.com
5.3 Manual Calibration Tab
The Manual Calibration tab in the XTR108EVM-USB software allows the user to program the XTR108
using a model file, perform a two-point calibration, calculate the post-calibrated error of the system, and
calibrate the overscale and underscale output values.
Figure 24 shows the Manual Calibration tab with default values. The following sections explain the use of
each section of the tab.
NOTE: The XTR108EVM-USB includes functionality to automatically control the Agilent 34401A
Multimeter. This functionality requires that the multimeter is connected to the user PC using
the NI GPIB-USB-HS controller, available separately.
Figure 24. XTR108EVM-USB Software, Manual Calibration Tab
36
XTR108EVM-USB Evaluation Board and Software Tutorial SBOU123–March 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated