Datasheet

Table Of Contents

www.ti.com

Software Setup

Table 19. XTR108EVM-USB Sensor Board Default Jumper Settings

Jumper Position Description

JMP1 FET Enable FET sub regulator

JMP2 FET Enable FET sub regulator

JMP3 IOUT Current-output mode

JMP4 NO LOAD Load resistor disconnected

JMP5 IOUT Current-output mode

JMP6 BYPASS Bypass SPI clock buffer on charge pump

JMP7 NO CLK Disable charge pump

JMP8 2-WIRE Select two-wire RTD

4 Software Setup

This section describes how to install the XTR108EVM-USB software.

4.1 Operating Systems for XTR108EVM-USB Software

The XTR108EVM-USB software is tested on the Microsoft Windows XP operating system (OS) with

United States and European regional settings. The software should also function on other Windows

operating systems. Please report any OS compatibility issues to the Precision Amplifiers E2E forum.

4.2 XTR108EVM-USB Software Installation

Follow these steps to install the XTR108EVM-USB software:

1. Software can be downloaded from the XTR108EVM-USB product folder, or from the disk included with

the XTR108EVM-USB that includes a folder called Install_software/.

2. Find the file called setup.exe. Double-click the file to start the installation process.

3. Follow the on-screen prompts to install the software.

4. To remove the application, use the Windows Add/Remove Software control panel utility.

4.3 Starting the XTR108EVM-USB Software

The XTR108EVM-USB software can be started through the Windows Start menu. Click Start → All

Programs → XTR108EVM-USB → XTR108EVM-USB to start the program, as shown in Figure 17.

Figure 17. Starting the XTR108EVM-USB Software

SBOU123–March 2012 XTR108EVM-USB Evaluation Board and Software Tutorial

Submit Documentation Feedback