Datasheet
Table Of Contents
- XTR108EVM-USB Evaluation Board and Software Tutorial
- 1 Overview
- 2 Hardware Overview
- 3 Hardware Setup
- 3.1 Electrostatic Discharge Warning
- 3.2 Connecting the Hardware
- 3.3 Connecting Power and USB to the USB DAQ Platform
- 3.4 Connecting Loop Power Supply to the XTR108EVM-USB Interface Board
- 3.5 Connecting Outputs to a Digital Multimeter (DMM)
- 3.6 USB DAQ Platform Default Jumper Settings
- 3.7 XTR108EVM-USB Interface Board Default Jumper Settings
- 3.8 XTR108EVM-USB Sensor Board Default Jumper Settings
- 4 Software Setup
- 5 Software Overview
- 6 General Operating Tips
- 7 Hardware Documentation
- 8 Appendix
- Important Notices
www.ti.com
Hardware Setup
3.7 XTR108EVM-USB Interface Board Default Jumper Settings
Figure 15 shows the default XTR108EVM-USB Interface Board jumper configuration. Table 18
summarizes the default jumper configuration. For more information about the jumpers on the Interface
Board, see Table 12.
Figure 15. XTR108EVM-USB Interface Board Default Jumper Settings
Table 18. XTR108EVM-USB Interface Board Default Jumper Settings
Jumper Position Description
JMP1 POT_RTD Use POT1, POT2 for the RTD emulator minimum-scale output
JMP2 POT_RTD Use POT3, POT4 for the RTD emulator mid-scale output
JMP3 POT_RTD Use POT5, POT6 for the RTD emulator maximum-scale output
23
SBOU123–March 2012 XTR108EVM-USB Evaluation Board and Software Tutorial
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated