Data Sheet

WL1801MOD,
WL1805MO
D
,
WL1831MO
,
WL1835MOD
SWRS152M JULY 2013 REVISED OCTOBER 2017
www.ti.com
12
Specifications
Copyright © 2013–2017, Texas Instruments Incorporated
Submit Documentation
Feedback
Product Folder Links: WL1801MOD WL1805MOD WL1831MOD
WL1835MOD
5.7 WLAN Performance: 2.4-GHz Transmitter Power
over operating free-air temperature range (unless otherwise noted). All RF and performance numbers are aligned to the
module pin.
PARAMETER
CONDITION
(1)
MIN TYP MAX
UNIT
RF_ANT1 Pin 2.4-GHz SISO
Output Power: Maximum RMS output power measured
at 1 dB from IEEE spectral mask or
EVM
(2)
1 Mbps DSSS
17.3
dBm
2 Mbps DSSS
17.3
5.5 Mbps CCK
17.3
11 Mbps CCK
17.3
6 Mbps OFDM
17.1
9 Mbps OFDM
17.1
12 Mbps OFDM
17.1
18 Mbps OFDM
17.1
24 Mbps OFDM
16.2
36 Mbps OFDM
15.3
48 Mbps OFDM
14.6
54 Mbps OFDM
13.8
MCS0 MM
16.1
MCS1 MM
16.1
MCS2 MM
16.1
MCS3 MM
16.1
MCS4 MM
15.3
MCS5 MM
14.6
MCS6 MM
13.8
MCS7 MM
(3)
12.6
MCS0 MM 40 MHz
14.8
MCS7 MM 40 MHz
11.3
RF_ANT1 +
RF_ANT2
MCS12 (WL18x5)
18.5
dBm
MCS13 (WL18x5)
17.4
MCS14 (WL18x5)
14.5
MCS15 (WL18x5)
13.4
RF_ANT1 +
RF_ANT2
Operation frequency range
2412 2484
MHz
Return loss
10.0
dB
Reference input impedance
50.0
(1) Maximum transmitter power (TP) degradation of up to 30% is expected, starting from 80°C ambient temperature on MIMO operation
(2) Regulatory constraints limit TI module output power to the following:
Channel 14 is used only in Japan; to keep the channel spectral shaping requirement, the power is limited: 14.5 dBm.
Channels 1, 11 @ OFDM legacy and HT 20-MHz rates: 12 dBm
Channels 1, 11 @ HT 40-MHz rates: 10 dBm
Channel 7 @ HT 40-MHz lower rates: 10 dBm
Channel 5 @ HT 40-MHz upper rates: 10 dBm
All 11B rates are limited to 16 dBm to comply with the ETSI PSD 10 dBm/MHz limit.
All OFDM rates are limited to 16.5 dBm to comply with the ETSI EIRP 20 dBm limit.
For clarification regarding power limitation, see the WL18xx .INI File Application Report.
(3) To ensure compliance with the EVM conditions specified in the PHY chapter of IEEE Std 802.11™ – 2012:
MCS7 20 MHz channel 12 output power is 2 dB lower than the typical value.
MCS7 20 MHz channel 8 output power is 1 dB lower than the typical value.