Datasheet

ManualsBrandsTEXAS INSTRUMENTS ManualsDev KitsPCB design board

Power

Supply

(optional)

HPA650

D28

J29

- +

J12

J13

XU1 with

UCD90124

Installed

J27

JTAG

RS232USB

5 V INPUT

ADDRESS

RESET

LED ENABLE

PC with GUI

USB CABLE

J26r

J25

J18 J19

J23 J24

J10 J11

J17 J20

J15r

J16

Device Pin 1

www.ti.com

UCD90SEQ64EVM-650 GUI Setup

Figure 1. Typical Test Setup

3 UCD90SEQ64EVM-650 GUI Setup

3.1 UCD90SEQ64EVM-650 GUI Installation

The UCD90SEQ64EVM-650 uses the TI Fusion Digital Power Designer GUI which may be downloaded

from the following Web site:

http://focus.ti.com/docs/toolsw/folders/print/fusion_digital_power_designer.html

Click the link for the official release for sequencers to start the download. Place the TI Fusion Digital

Power Designer zip file in a known location on the PC. Unzip the TI Fusion Digital Power Designer zip file.

Double-click the unzipped TI Fusion Digital Power Designer .exe file. Proceed through the installation by

accepting the installer prompts and the license agreement. Accept the GUI-suggested default PC

installation locations to complete the install.

Once the GUI completes the installation, the program starts. The first time the GUI is launched on a

particular PC, the user may be prompted to select a device. Choose UCD9xxx. Afterwards, the GUI may

be closed.

Note that the TI Fusion Digital Power Designer version 1.7.165 was used for the GUI figures in this

document.

SLVU423–December 2010 UCD90SEQ64EVM-650:— 64-Pin Sequencer Development Board

Submit Documentation Feedback